VG4 Modular Camera Series
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
23
Bosch Security Systems, Inc.
Installation Manual
F.01U.216.010 | 8.0 | 2011.02
3.
Attach the supplied 3-pin power plug to the incoming high voltage power wires in the
box. Refer to connector P101 in
Table 2.2, Page 22
and to the image below for an
illustration of these connections:
Figure 2.6
Incoming 115/230 VAC power supply
4.
Attach the ground wire to the grounding screw.
5.
Connect three wires to the P107 Power Out connector to route the 24 VAC power supply
to the VG4-PA0 Power Supply Box.
a.
Connect the first wire to pin 5 (HN: Heater Neutral) connector.
b.
Connect the second wire to pin 4 (HL: Heater Line) connector.
c.
Connect the third wire to pin 3 (Earth Ground) connector.
Refer to connector P107 in
Table 2.2
and to the image below for an illustration of
these connections:
Figure 2.7
Outgoing 24 VAC power supply
6.
Route the 24 VAC outgoing power supply wires into the VG4-PA0 power supply box
through the conduit fitting on the left side of the box.
7.
Cut and trim the 24 VAC power and ground wires with sufficient slack to reach their
connector terminal in the box, but not so long as to be pinched by or to obstruct closing
the cover door.
P101
24V NC 24V
1 2 3
P107
5 4 3 2 1
HTR DOME
WARNING!
Ensure that you connect the outgoing power supply wires to the P107 heater connectors (HN
and HL). The heater power (XF103) fuse can handle a higher amperage (3.15 A) than the
camera power (XF102) fuse (2.0 A).
Summary of Contents for VG4 Series
Page 1: ...VG4 Modular Camera Series VG4 Series en Installation Manual ...
Page 2: ......
Page 107: ......
