Technical data
9
Tronic 2500 TO – 6 720 879 724 (2019/10)
approx. 4 litres of water to flow. Then plug the mains plug back in.
The appliance is ready again for operation.
2.5.3
Limitation of the water temperature
The temperature of the water leaving the tap for the small water heater
can be mechanically set to stage
“1”
(approx. 40 °C) or stage
“eco”
(approx. 60 °C) (see “Operation”, page 9).
Conserving energy
• Set the rotary selector to
“eco”
to conserve energy.
• Hand over the installation and operating instructions to the user and
explain how the appliance operates.
3
Technical data
4
Operating instructions
•
Before using the appliance, please read the instructions
carefully and observe them!
•
Important
: The appliance may never be exposed to frost!
WARNING:
Risk of electric shock!
If a fault occurs, immediately disconnect the plug from the power
supply!
Immediately shut off the cold water supply to the appliance should
it leak.
Please read and observe the detailed safety instructions at the start
of these instructions!
Operation
The small water heater heats and stores drinking water up to approx. 85 °C.
• The warm water outlet of the small water heater serves for pressure
equalisation and my be connected only to the pressureless batteries
BZ 13051 or BZ 13062 (below basin) or BZ 11113 (above basin).
4.1
Setting the water temperature
• The required outlet temperature from 40 °C to 85 °C can be set with
the rotary selector switch.
or:
• Set the required fixed outlet temperature:
The pilot lamp lights up during heat up.
Water drips out of the tap with oversink appliances.
The appliance with be covered more quickly with limescale at higher
temperatures.
Tip
: Set the rotary selector switch to
“eco”
to operate the appliance
economically and to reduce the effects of limescale.
Note
: If the appliance has not been used for an extended period,
e. g. during a holiday, allow the water to briefly heat up to stage “
3
”.
4.2
Limitation of the water temperature
Limit the outlet temperature to avoid scalding with hot water:
• Set the rotary selector switch to “●”.
• Open the cover of the rotary selector switch.
• Select between
“1”
= approx. 40 °C or
“eco”
= approx. 60 °C.
• Close the cover.
Type
TR2500TO 10 T
Undersink
TR2500TO 10 T
(CH)
Undersink
TR2500TO 10 B
Over-sink
TR2500TO 10 B
(CH)
Over-sink
Rated output
[kW]
2,2
1,8
2,2
1,8
Rated capacity
[l]
10,0
10,0
10,0
10,0
Mixed water quantities 40 °C
(15 °C/85 °C) / (15 °C/85 °C)
[l]
19
28
19
28
Variable temperature adjustment up to
[°C]
85
85
85
85
Stand-by power consumption at 65 °C/24 h
[kWh/d]
0,3
0,3
0,3
0,3
Electrical connection
[V]
220-240
220-240
220-240
220-240
Heat-up time to 60 °C
(supply temperature 12 °C)
[min]
15
17
14
19
Fuse protection
[A]
10
10
10
10
Water connection
["]
17,2(G3/8A)
17,2(G3/8A)
21,3(G1/2A)
21,3(G1/2A)
Maximum flow
[l/min]
10
10
10
10
Cable length
[m]
0,7
0,7
0,7
0,7
Dimensions (Height×Width×Depth)
[mm]
460×295×285
460×295×285
461×295×285
461×295×285
Weight, filled
[kg]
13,7
13,7
13,7
13,7
Energy efficiency class
A
A
A
A
Load profile
XXS
XXS
XXS
XXS
Annual energy consumption
[kWh]
486
526
524
520
Daily energy consumption
[kWh]
2,360
2,484
2,472
2,446
Sound power level
[dB]
15
15
15
15
Hot water heating energy efficiency
[%]
36,5
35,1
35,2
35,5
●
Cold
Frost protection
1
Approx. 40 °C (soft lock-in)
eco
Conserve energy approx. 60 °C (soft lock-in)
3
Hot water approx. 85 °C
