12
SIEMENS
ENG
lISH
Instructions for use
pOSITIONING
When setting up the ironing board please
note the following:
• Place the ironing board on a flat, even, dry
surface, near an earthed mains socket.
• Position the ironing board securely so that
nobody can knock it over or get hurt.
• Never put the appliance on or near warm
surfaces or near flames.
• Use the appliance in dry rooms only.
• To avoid scalding, keep the appliance away
from children.
• Use only the correct extension cables; be
careful not to trip over the cord.
put up the ironing board as follows:
• Place the ironing board upright on the floor
(iron storage shelf end downward).
• Hold the end of the ironing board with one hand.
• With the other hand hold the upper part of the
ironing board legs.
• Firmly pull the ironing board wide apart
❶
, until
the adjustment height device locks in place
➋
.
• Place the ironing board in a horizontal position
➌
.
• To adjust the height, take hold of the ironing
board with both hands. Lift the ironing board up
slightly and pull the lever with one hand.
(The ironing board has to be slightly raised for
safety reasons, i.e. to prevent the lever from
being activated accidentally.) Only when you
hear the ironing board lock into place is it secure.
11
2
3
Note:
Be careful that the feet of the ironing board
don’t slip on smooth floors while opening/closing
the ironing board.
• Insert the iron cord support in one of the small
holes each side of the ironing board and hang
the steam power cord. The iron cord support
prevents unwanted movement by cord drag of
the garment being ironed as well as the wear of
the steam power cord.
There are two holes one each side at the rear
end of the ironing board so that the cord support
can be positioned for right or left handed use.
STarT Up
If you are using a steam generator:
• Place the iron/steam generator on the shelf.
If you are using a steam iron:
• Place the iron (soleplate down) on the iron rest
mat which should be positioned at the rear end
of the ironing surface.
• Plug the power supply cord from your iron/
steam generator into the auxillary socket
built-in to the ironing board.
• Plug the power supply cord from your ironing board
into a 13amp wall socket and switch the socket on.
• Switch the equipment on using the power on/off
switch. The power on/off switch acti-vates the
ironing board and the steam generator or steam
iron plugged into the auxillary socket. An integrated
thermostat constantly controls the board heating
temperature. During the heating phase the
equipment may emit noises. This is a normal
phenomenon, which is nothing to worry about.
Power on/off switch
Power indicator light
SUCTION FUNCTION aND HEaTING
OF BOarD
The suction absorbs the superfluous steam,
which is no longer used after the ironingprocess.
The suction helps hold the garment on the ironing
surface and helps to dry the garment. Clean ,dry
clothes are obtained, ready to be placed straight
in the wardrobe without further airing. The heated
ironing surface stays dry, and keeps the steam
