Bosch SRS2IKW04E, User Manua

Page: 22 / 56

NL Softening System
Remark: Set the device to the
determined water hardness.
→ "Setting water softening",
Page 22
With a water hardness of 0 - 6 °dH
you do not need to use softening
salt for dishwashers and you can
switch off the water softening.
→ "Switch off water softening",
Page 23
The amount of softening salt
depends on the water hardness. The
higher the water hardness, the
greater the amount of softening salt
required.
PAY ATTENTION!
s Dishwasher detergent can damage the water
damage hardening.
▶
The reservoir of the softener
Only fill the water supply with
special salt for dishwashers.
s The rinse aid container can be
corrode softening salt for
dishwashers.
▶
To ensure that
spills out of the softening salt
from the rinse aid container, the
softening salt must be filled into
the water softening salt
reservoir immediately before the
program starts.
Set water softening
Set the appliance to the water
hardness.
1.
Determine the water hardness and
the desired setpoint.
→ "Overview of the water hard-
health settings", page 21
2.
on to press.
3.
To access the device settings,
press . for 3 seconds
to press.
a flashes in the display.
1.
Open the lid of the softening salt
reservoir and remove it.
4.
Press as many times until
the desired water hardness has
been set.
2.
When using for the first time: fill the
reservoir completely with water.
Depending on the burning mode
0, 1, 2 or 3 LEDs.
→ "Overview of the water hard-
health settings", page 21
The factory setting is position 1
("LED A" →
page 15).
5.
To save the settings, press for
approx. 3 seconds.
softening salt
You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the start of the
programme. The required amount
22