Bosch SMS40C02GB, Operating Instructions Manual

Page: 8 / 28

en
8
As soon as the rinse-aid refill indicator
`
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
–
Open the dispenser
1j
by pressing
and lifting the plate on the cover.
– Carefully pour rinse aid up to the max.
mark in the filler opening.
– Close cover until it clicks shut.
– To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.
Setting amount of rinse aid
The amount of rinse aid can be set from
§
:
‹‹
to
§
:
‹‡
. Please set rinse aid on
§
:
ܠ
to obtain very good drying results
(
§
:
ܠ
is already set in factory).
Change this setting, only if streaks (select
lower setting) or water stains (select higher
setting) are left on the utensils.
–
Close the door.
– Switch on ON/OFF switch
(
.
– Press and hold down the START
button
@
.
– Rotate programme selector
8
until
§
:
‹
... s indicated on the digital
display
H
.
– Release button.
The factory set value
§
:
ܠ
is lit on the
digital display
H
.
To change the setting:
– Rotate programme selector
8
until
the required value is indicated on the
digital display
H
.
– Press START button
@
.
The set value is saved.
Switching off rinse aid refill
indicator
If the rinse-aid refill indicator
`
is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
–
Proceed as described under “Setting
amount of rinse aid” and set the value
to
§
:
‹‹
.
The rinse aid refill indicator
`
is now
switched off.
Rinse aid
%
PD[