en
6
To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above a specific degree of
water hardness must be softened, i.e.
descaled, for use in a dishwasher. Water is
softened with special salt in the water
softening system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).
Setting
The amount of salt dispensed can be set
in 4 stages depending on the hardness of
your water. Accordingly 0, 1, 2 or 3
displays are lit (see table). Factory setting:
1.
–
Find out about the hardness value of
your tap water. Your water utility
company will help you with this.
–
Setting can be found in the water
hardness table.
–
Close the door.
–
Switch on ON/OFF switch
(
.
–
Press and hold down the START
button
@
.
–
Rotate programme selector
8
until
the salt refill indicator
`
flashes.
–
Release button.
The salt refill indicator
`
flashes and
the display “Check water supply”
h
are lit (= Setting 1).
To change the setting:
–
Rotate programme selector
8
until
the required setting has been selected.
–
Press START button
@
.
The salt refill indicator
`
goes out.
The selected setting is saved.
Water hardness table
Water softening system
,
End
6
° Clarke
0 - 8
soft
9 - 20
medium
21 - 26
hard
27 - 44
hard
mmol/l
0 -1,1
1,2-2,9
3,0-3,7
3,8-6,2
Hardness
range
Setting
0
1
2
3
Downloaded from DishWasher-Manual.com Manuals
