en
16
Spray arm
Limescale and dirt from the rinsing water
may block nozzles and the bearing
assemblies of the spray arm
1"
.
–
Check outlet nozzles on the spray arm
for blockages.
–
Remove the spray arm upwards.
–
Clean the spray arm under running
water.
–
Lock the spray arm into position.
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block the
waste water pump. The rinsing water is
then not pumped out and covers the filter.
In this case:
–
First disconnect the appliance from the
power supply.
–
Remove the filters
1*
.
–
Scoop out water, use a sponge if
required.
–
Loosen screws on the pump cover
(Torx T 20) and pull off.
–
Check inner compartment and remove
any foreign objects.
–
Place pump cover in the original
position, press down and screw tight.
–
Install filters.
