en
14
Timer programming *
* depending on model
You can delay the start of the programme
by 3, 6 or 9 hours.
–
Switch on ON/OFF switch
(
.
–
Keep pressing the Preselected starting
time button
@
until the appropriate
display 3h, 6h or 9h is lit.
–
Press START button
8
, timer
programming is activated.
–
To delete the preselected starting time,
keep pressing the Preselected starting
time button
@
until none of the
displays 3h, 6h or 9h is lit.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the End
display
h
is lit.
Switching off the appliance
Short time after the end of the programme:
–
Switch off ON/OFF switch
(
.
–
Turn off the tap (not applicable if Aqua-
Stop fitted).
–
Remove the utensils when they have
cooled down.
ã=
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
–
Switch off ON/OFF switch
(
.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
–
To continue the programme, switch on
the ON/OFF switch
(
again.
Terminating the programme
(Reset)
–
Press START button
8
for approx.
3 sec.
The End display
h
is lit.
–
The remaining programme sequence
lasts approx. 1 minute.
Switch off ON/OFF switch
(
.
Changing the programme
When the START button
8
has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).
Intensive drying
The final rinse uses a higher temperature
which improves the drying result. The
running time may increase slightly.
(Caution if utensils are delicate!)
–
Close the door.
–
Switch on ON/OFF switch
(
.
–
Press and hold down the START
button
8
.
–
Rotate programme selector
0
until
the “Check water supply” display
`
flashes.
–
Release button.
To change the setting,
–
By rotating the programme selector
0
, you can switch on intensive
drying (End display
h
is lit) or switch
off intensive drying (End display
h
is
not lit).
–
Press START button
8
.
The setting is saved.
