en-us
Operating the Dishwasher
32
Switching the appliance on
1.
Turn the water supply on fully.
2.
Open the door.
3.
Press the
On/Off
button
(
.
The display of the last selected
wash cycle flashes. This wash
cycle remains selected if no other
wash cycle button
0
is pressed.
The expected wash cycle duration
flashes on the display
8
.
Select any desired option.
4.
Press
Start
button
P
.
Wash cycle sequence starts.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Time display
When a wash cycle is selected the
remaining wash cycle time is shown
on the display
8
.
The wash cycle time is determined
during the wash cycle by the water
temperature, the amount of dishes,
as well as the degree of soiling and
may vary (depending on the selected
wash cycle).
Delay Start
You can delay the start of the cycle in
one hour increments up to 24 hours.
To set Delay start:
1.
Open the door and press the
On/Off
button
(
. Select a cycle.
2.
Press the
Delay
button from the
wash cycle options
H
until the
displayed time corresponds with
your requirements.
3.
Press the
Start
button
P
to
activate Delay start.
To cancel Delay start:
1.
Open the door and press the
Delay
button until
œ
:
‹‹
is
indicated on the digital
display
8
.
2.
Press the
Start
button
P
to
save setting.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Wash cycle end
The wash cycle has ended when the
display
8
reads
‹
:
‹‹
.
If the signal tone has been set, the
wash cylce end is also indicated by a
buzzer.
To change the signal volume:
1.
Open the door.
2.
Press the
On/Off
button
(
.
3.
Hold down function key
#
and
press
Start
button
P
until the
display
8
indicates
•
:
‹
x (x can
be any number).
4.
Release both buttons. The LED for
function key
#
flashes and teh
digital display shows the factory
setting
•
:
‹…
.
5.
Press function key
#
until the
display shows
›
:
‹ƒ
.
œ
:
‹‚
1 hour delay
œ
:
ƒ…
24 hours delay
›
:
‹‹
Off
›
:
‹‚
low
›
:
‹ƒ
medium
›
:
‹„
loud
