Bosch SHP865W75N, Operating Instructions Manual

Page: 28 / 88

en-us
Operating the Dishwasher
28
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Open the door.
2.
Switch off On/Off button
(
.
3.
Turn off water supply.
4.
Remove the utensils when they
have cooled down.
9
WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9
CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Open the door.
2.
Switch off On/Off switch
(
.
The LED’s go out. The wash cycle
is saved.
3.
To continue the wash cycle,
switch on the On/Off switch
(
again.
4.
Close the door.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Terminating the wash cycle
(Reset)
Terminati ng the wa sh cycle
1.
Press and hold
Start
button
P
for approximately 3 seconds until
the display reads
‹
:
‹‚
.
2.
Wait about 1 minute while the
dishwasher drains.
3.
Press
On/Off
button
(
.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the
Start
button
(
has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
Intensive drying
The final rinse uses a higher
temperature which improves the
drying result. The cycle time may
increase slightly. (Caution if utensils
are delicate!)
This feature has two settings:
1.
Open the door.
2.
Press the
On/Off
button
(
.
3.
Hold down function key
#
and
press
Start
button
P
until the
display
8
indicates
š
:x (x can
be any number).
4.
Release both buttons.
5.
Press function key
#
until the
display
8
indicates the factory
set value
š
:
‹‹
.
š
:
‹‹
Off
š
:
‹‚
On