en-us
Operating the Dishwasher
30
To change the setting:
1.
Press the
On/Off
button
(
.
2.
Hold down the function key
#
and press the
Start
button
P
until the display
8
indicates
š
:
‹
x (x can be any number).
3.
Release both buttons.
4.
Press the function key
#
until
the display
8
indicates
˜
:
‹
x.
5.
Press the function key
3
until
the display corresponds with your
requirements.
6.
Press the
Start
button
P
.
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Press
On/Off
button
(
.
2.
Turn off water supply.
3.
Remove the utensils when they
have cooled down.
9
WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9
CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Press
On/Off
button
(
.
The LED’s go out. The wash cycle
is saved.
2.
To continue the wash cycle, close
the door and press
On/Off
button
(
again.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button
P
again.
Terminating the wash cycle
(Reset)
Terminati
ng the wa
sh cycle
1.
Press and hold
Start
button
P
for approximately 3 seconds until
the display reads
‹
:
‹‚
.
2.
Wait about 1 minute while the
dishwasher drains.
3.
Press
On/Off
button
(
.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the
Start
button
(
has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
