12
Rinse Agent Dispenser
open the rinse agent dispenser by lifting the tab with your thumb as shown in
figure 17.
add liquid rinse agent to the dispenser as shown in figure 18 until the rinse agent reservoir
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE:
the dishwasher indicates low rinse agent either by showing the symbol
in the
countdown display, or illuminating the reill rinse agent light as shown in
figure 19 (model
dependent).
NOTE
:
After illing the rinse agent dispenser, the indicator light will go out in a few minutes
after the dishwasher door is shut (select models).
Operating the Dishwasher
always make sure your dishware is dishwasher safe. refer to the
Dishware Materials
section
of this manual for guidance.
Wash Cycles
Power Scrub Plus
Cleans items having baked-on or hard dried-on food soils. these items may require soaking
or hand scouring.
Regular
thoroughly cleans large loads having loosely attached normal soiling.
Delicate/Economy
for delicate or heirloom dishwasher and silverware or other special items. always make sure
that the items are dishwasher safe. refer to the Materials section of this manual for further
information. Hand washing may be the best treatment of such items.
Quick Wash
for lightly soiled items with easy to remove food soils.
Rinse and Hold
allows you to rinse the food soil off of a partial load and hold them in the dishwasher until
there is a full load.
More information on dishwasher cycles is located in the Wash Cycle information section of
this manual.
Wash Cycle Options
Half Load
in the power scrub plus, regular and auto Wash cycles you can reduce the energy and water
consumption when washing small, lightly soiled loads that ill approximately half of the
dishwasher’s capacity. to activate, select the Half load button in addition to the power scrub
plus, regular or auto Wash cycle button.
Extra Dry Heat
With this option you can raise the temperature of the rinse water and increase the drying time
which will result in improved drying.
NOTE
: the unit must be powered off before activating
to activate:
· Press and hold the left “Cancel / Drain” button (see Figure 20), then press and hold the
on/off button.
· When the LED display shows a “00” or a “01” release both buttons.
· To enable the Additional Drying Heat, press the left “Cancel / Drain” button until the LED
display shows a “01”.
· To disable the Additional Drying Heat, press the left “Cancel / Drain” button until the LED
display shows a “00”.
Figure 19
Figure 20
