13
Cycle completion signal:
The cycle completion signal alerts you when a cycle completes and the dishwasher has washed and dried the
dishes. You can choose to disable the tone or adjust the volume.
To activate:
1
With the unit OFF, press and hold the right of the two
Cancel/Reset
buttons and then press and hold the
On/
Off
button.
2
When the light on the
Cancel/Reset
button you are pressing illuminates and the tone goes off, release both
buttons.
3
Press the right of the two
Cancel/Reset
buttons again until you achieve the desired volume or until there is
no tone (to turn cycle completion signal OFF).
4
Press the
On/Off
button to save the setting.
Care and Maintenance
Maintenance Tasks
Certain areas of the dishwasher require occasional maintenance. The maintenance
tasks are easy to do and will ensure continued superior performance from your dish-
washer.
Wiping up spills and splash-outs
Water may occasionally splash out of your dishwasher, particularly if you interrupt a
cycle or open the dishwasher door during a cycle. To avoid floor damage and possibly
mold growth, do not allow wet areas to remain around or under the dishwasher.
Clean the stainless steel inner door and tub
Clean the outer edges of the inside door panel regularly to remove debris that may col-
lect from normal loading. If spots begin to appear on the stainless steel, make sure the
rinse agent is full and functioning properly.
Check and clean spray arm nozzles
Remove the top spray arm by first removing the empty top rack from the dishwasher.
Turn the rack upside down. The top spray arm is held in position by a locking nut as
shown in
Figure 10
. Turn the locking nut counterclockwise and remove it to release the
spray arm. Look for obstruction in the spray nozzles. If the spray nozzles need clean-
ing, flush them under running water.
To reinstall the top spray arm, place it back in position and return the lock-
ing nut to its install position. Turn the locking nut clockwise to secure.
Return the top rack to the top rack roller guides.
Remove the bottom spray arm by first removing the empty bottom rack
from the dishwasher. Grasp and lift the spray arm as shown in
Figure 11
.
Look for obstruction in the spray nozzles. If the spray nozzles need clean-
ing, flush them under running water.
To reinstall the bottom spray arm, return the bottom spray arm to the
installed position and press it until it snaps into place. Return the bottom
rack to the installed position.
Check and clean the filter system
The filter system consists of a Large Object Trap/Cylinder Filter assembly, a Fine Filter
and a Micro Filter. The filter system is located on the inside of your dishwasher under
the lower rack and is easily accessible. During normal use, the filter system is self-
cleaning. You should occasionally inspect it for foreign objects and clean it when nec-
essary.
Trap
Filter
Cylinder
Fine Filter
Figure 12
Figure 10
Figure 11
Large Object