Bosch SGS 44E18, Instructions For Use Manual

Page: 7 / 32

en
7
Water softener
In order to rinse dishes and glasses
satisfactorily, the dishwasher requires soft
water, i.e. containing little or no lime,
otherwise water stains will be left behind
on crockery and glasses, etc.
If the tap water exceeds a certain level of
hardness, it must be softened, i.e.
decalcified, so that it can be used in the
dishwasher.
This is achieved by adding a special salt
to the water softener inside the
dishwasher.
The water softener, that is the required
amount of salt, is set up according to how
hard the tap water is.
Setting up the water softener
Determine the level of hardness of your
tap water. Your local water company or
service agent can help you with this.
Identify setting from the following water
hardness table.
Close the door
Rotate the programme selector
3
from the 12 o’clock position by one
notch to the left.
Switch on main switch
1
and hold
down for at least 3 sec.
The display
9
flashes and the lamps
above the symbols and light up.
(hardness value has been set to 2
at the factory).
To change the setting: Rotate the
programme selector
3
.
You can select a set value between
0 and 3 according to the hardness
of your water.
If the lamps , and light up,
the maximum set hardness value
has been reached. If the set hardness
value is now increased again, the
lamps go out and the set hardness
value is set to 0 (no lamp lights up).
Switch off the main switch
1
.
The chosen setting has now been
stored.
Water hardness table
_
dh
_
Clarke mmol/l
_
fH
0–6
17–21
7–16
22–35
0
2
1
3
0–11
30–37
12–29
38–62
0–8
21–26
9–20
27–44
0–1,1
3,0–3,7
1,2–2,9
3,8–6,2
Downloaded from DishWasher-Manual.com Manuals