en-us
Troubleshooting
42
Food soils on
the dishes.
Dishes placed too closely together,
racks overfilled.
Arrange dishes with adequate clearance
between them ensuring that the spray jets
can reach the surface of the dishes. Prevent
contact points.
Spray arm rotation obstructed.
Arrange dishes so that the spray arm can
rotate without obstruction.
Spray arm nozzles are blocked.
Clean the spray arm nozzles.
Filters
1b
dirty.
Clean filters.
Filters
1b
inserted incorrectly
and/or not engaged.
Insert and engage filters correctly.
Rinse wash cycle too weak.
Select a more intensive rinse cycle.
Increase sensitivity of the sensors.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Do not pre-rinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Normal" or
Intensive.
Tall narrow containers in corner
areas are not rinsed adequately.
Do not lean hollow containers too much and
do not place them in the corner area.
Upper rack
12
on right and left
not set to same height.
Set upper rack to same height using side
levers.
Dishwasher
seems to run a
long time
Incoming water is not warm
enough.
Before starting a cycle, run hot water faucet
at the sink closest to the dishwasher.
Cycle time can vary due to soil and
water conditions.
Sensors in the dishwasher automatically
increase the cycle time to ensure a good
wash when heavy soil is detected.
Rinse aid dispenser
9*
is empty. Add rinse aid.
Dishwasher connected to cold
water supply.
Note:
Check the typical wash cycle
length.
Verify dishwasher is connected to hot water
supply plumbing.
Fault
Cause
Remedial action
* This is an optional feature which may or may not be included with your dishwasher.
Summary of Contents for SGE53X52UC
Page 2: ...2 ...
