DSS user interface
4–12
1070 066 091-102 (01.08) GB
4.6
Important drive commands
4.6.1
Changing phases
.
You have to use the DSS to change over to phases 0 to 4.
When booting, the drive only needs phases 2 and 4 (cf. page 3–12).
active phase
Possible phases:
0
1
2
3
4
Various parameters can only be changed in certain initialization phases.
Therefore, during commissioning, you first have to switch the drive to the re-
quired phase before changing such parameters. If you forget changing
phases, an error message of the type ” Data of parameter x-0-xxxx is write
protected at this time!” will usually be output.
You may change to the
higher next phase
by:
D
Menu sequence CONTROL
"
INCREMENT INITIALIZATION PHASE
– or –
D
Icon bar: Click on
– or –
D
"
INCREMENT INITIALIZATION PHASE
in the ”Overview” window.
You may
change back to phase 0
by
D
Menu sequence CONTROL
"
DECREMENT INITIALIZATION PHASE
– or –
D
Icon bar: Click on
– or –
D
"
DECREMENT INITIALIZATION PHASE
in the ”Overview” window.
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01