Bosch Sensixx B35L, Operating Instructions Manual

Page: 17 / 158

17
BOSCH
ENGLISH
* Model dependent
COrK HaNDLE IrON
(model dependent)
To get permanent steam, press the lock
button (16*) and slide it backwards until it
locks.
To switch off the permanent steam, slide the
lock button forward.
Important:
• The steam hose may get hot if you are ironing
for long periods.
“pulseSteam”
function
(model dependent)
This appliance has a special function for tackling
difficult creases.
The “pulseSteam” function helps soften stubborn
garments like jeans or linen faster.
When the steam release button is activated, the
steam generator will release three powerful shots
of steam so that the steam reaches even deeper
into the fabrics.
1. Set the temperature selector (11) on “•••”
2. Briefly press the steam shot button (12*) on the
top of the handle.
or (model dependent)
press the steam release button (12) on the
bottom of the handle two times in quick
succession (double-click).
remarks:
• it is possible to stop the shots of steam by
quickly pressing the steam button again.
• Some water drops may appear when you use
the “pulseSteam” function for the first time.
The water drops will disappear after you have
used the function for some time.
Ironing without steam
Begin ironing but without pressing the steam
release button.
3
vertical steam
This can be used to remove creases from
hanging clothes, curtains etc.
Warning!:
Never direct the steam jet at garments that
are being worn.
Never aim the steam at people or animals.
1. Set the temperature to the “•••” setting.
2. Hold the iron in an upright position 15 cm away
from the garment being steamed.
3. you can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing
the iron in a vertical position and pressing the
steam release button (12-13*).
“Intelligent steam” function
(model dependent)
This system has intelligent steam control, which,
after releasing the steam release button (12-13*),
provides a small amount of additional steam.
The additional steam can always be stopped by
briefly pressing the steam release button once
again.
Energy saving “eco”
setting
(model dependent)
if the “eco” steam setting on the steam control
(5*) is selected, the energy consumption of
the appliance will be reduced, by means of the
reduction of water consumption and electricity.
a good ironing result can be obtained for most
garments.
Use higher settings only for thick and highly
wrinkled fabrics.
auto shut-off
(model dependent)
if during ironing, the steam release button
(12-13*) on the iron handle is not pressed for
a certain length of time (8 minutes), the steam
station will automatically switch off.
The “auto shut-off” pilot lamp (4) will flash when
auto shut-off has been activated.
To switch the steam station back on, press the
steam release button again.