7
of
1
2
ISSUED: 06-25-99 SHEET #: 039-9003-8 02-08-05
Q
P
R
DETAIL 2
K
Position TV onto support tray (
A
). Position anti-rollout hooks (
R
) against front edge of TV.
FIRST:
From the top fully thread flush mount tube
(
T
) into threaded fitting in wall arm or ceiling plate.
Install the wall arm or ceiling plate according to
instructions included with it.
NEXT:
Attach right and left tilt brackets (
AA
&
BB
)
to horizontal support (
S
) using four screws &
washer combo (
J
). Before tightening screws make
sure tilt brackets are adjusted horizontally to align
precisely with screws in the side of vertical support
arms (
P
). Attach horizontal support (
S
) to wallarm
or ceiling plate using fiber washers (
M
&
N
), spacer
(
U
, only included with smaller models) and retaining
collar (
O
).
IMPORTANT:
Retaining collar (
O
)
requires a safety screw [refer to DETAIL 3, page 8].
FINALLY:
Be sure that hooks in right and left tilt
brackets (
AA & BB
) are open end forward. Hang the
TV / bracket assembly.
AA
BB
Wall arms & ceiling plates
include their own
instructions. Fixed length
and adjustable extension
columns are also available.
CMJ 470,
CMJ 480,
CMJ 490
WMJ 018,
WMJ 022
P
M
O
U
N
T
T
S
*
*
Included with models
TC9217MM
and
TC9220MM
only.
**
**
Note:
Slots in corners of top clamps (
Q
) and corners of vertical support arms (
P
) allow for the installation of safety belt
(model
ACC 666
, sold separately). If using this belt, install it now.
WMJ 025H
J
WARNING
• Each anti-rollout hook (R) should have at least 1/4” of surface contact with the front of the TV. If this is not the
case the support tray (A) must be adjusted smaller [see step 2], or the vertical support arms (P) adjusted inward
[see step 4].
Insert top clamps (
Q
).
Note:
Top clamps (
Q
) fit between rollout protectors (
R
) and vertical support arms (
P
)
[DETAIL 1]. Press down on each top clamp (
Q
) while securely tightening each M6 screw (
Z
).
By hand, thread one serrated flange head screw (
K
) into each vertical support arm (
P
) into one of three threaded
holes [1, 2, or 3; DETAIL 2]. Choose the threaded hole that will allow just enough tilt clearance [see step 9].
Leave about 1/4" of exposed thread.
• Do not lift more weight than you can handle!
Use additional manpower or mechanical lifting
equipment to safely lift and hang the TV /
Bracket assembly!
WARNING
Insert one screw & washer combo (
J
) through slot
in each tilt bracket (
AA & BB
). Hand tighten.
P
R
R
Q
Q
A
Q
P
R
Z
DETAIL 1
Summary of Contents for Security Systems TC9217MM-W
Page 11: ......
