Bosch Security Systems |
9/19
| 34453D
EN |
6
SE2 Series
| User Guide & Setup Instructions | 2.0 Part II - Setup Instructions
Figure 5: Jumper Positions
1 - Off
2 - On
1
2
Remove the battery before moving the
jumpers.
2.3
Enabling/Disabling Features
Figure 4
shows the location of the specific jumper for
each feature. Note that the lanyard-snatch jumper and
lanyard switch are only included on the SE2M,
SE2S-SN, and SE2U-SN models.
Figure 4: Internal Components
1 - Lanyard switch
2 - Man-down jumper
3 - Supervision jumper
4 - Lanyard jumper
5 - Battery compartment
+
-
5
4
3
2
1
2.3.1
Supervision Feature
To enable the supervision tracking feature, place its
jumper in the ON position, as indicated in
Figure 5
. Do
this by moving the jumper to cover both pins using a
small pair of pliers. With supervision tracking enabled,
the transmitter sends a silent transmission to the central
console approximately every 90 seconds. This enables
the central console to monitor the battery and
transmitter condition, as well as track the transmitter’s
location within the protected area.
2.3.2
Man-Down and Lanyard Snatch Features
To enable the man-down and lanyard snatch features,
place the desired feature jumper in the ON position as
shown in
Figure 5
. Use a small pair of pliers to move the
jumper so it covers both pins.
See
Section 1.2.2 Optional Features
for descriptions of
these features.
2.3.3
Battery
The transmitter uses a CR2, 3 V lithium battery. The
central console indicates when the battery is low and
needs replacement.
See
Figure 4
for battery polarity. The battery life
depends on usage and enabled features.