Bosch sce53m05au, Operating Instructions Manual

Page: 12 / 23

en
12
Aqua sensor
Aqua sensor *
* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
“clean” rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 2–4 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted to
the degree of soiling.
Switching on the appliance
– Turn on the tap fully.
– Switch on ON/OFF switch
(
.
The display of the last selected
programme flashes. This programme
remains selected if no other
programme button
0
is pressed. The
expected programme duration flashes
on the digital display
`
.
– Press the START button
H
.
The programme starts running.
Remaining running time display
When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
`
.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
–
Close the door.
– Switch on ON/OFF switch
(
.
– Press button
8
+ until the digital
display
`
jumps to
œ
:
‹‚
.
– Press
8
+ or – button until the
displayed time corresponds with your
requirements.
– Press START button
H
, timer
programming is activated.
– To delete timer programming, press
the
8
+ or – button until
`
œ
:
‹‹
is
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value
‹
:
‹‹
is indicated on the numerical
display
`
.
Switching off automatically after the end of the programme
Switching off automatically after
the end of the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the programme
ends (factory setting).
Automatic disconnection can be adjusted
from
˜
:
‹‹
to
˜
:
‹ƒ
.
– Close the door.
– Switch on ON/OFF switch
(
.
– Hold down programme button
#
and
press START button
H
until
š
:
‹
... is
indicated on the digital display.
– Release both buttons.
– Press programme button
#
until the
factory set value
˜
:
‹‚
is indicated on
the digital display
`
.
To change the setting:
– Press programme button
3
.
Each time the button is pressed, the
set value increases by one level; when
the value of
˜
:
‹ƒ
has been reached,
the display jumps back to
˜
:
‹‹
(off).
– Press START button
H
.
The set value is saved.
Washing the dishes
˜
:
‹‹
Appliance does not switch off
automatically
˜
:
‹‚
Off after 1 min
˜
:
‹ƒ
Off after 120 min