Bosch SB Series, Instructions Manual

Page: 15 / 64

Set up and connect NL
O
O
set up and connect
set up and connect
a continuous worktop that is firmly
connected to the adjacent cupboards.
For correct use, connect the
appliance to electricity and water in a
professional manner. Observe the
required criteria and the installation
instructions.
1.
Observe the safety instructions. →
Page 4
2.
Observe the instructions for the
electrical connection.
→ Page 16
Contents of the package
3.
The contents of the package
→ Page 15 and the condition of
check the device.
After unpacking, check all parts for
transport damage and for
completeness of the delivery.
If you have any complaints, please contact
the shop where you purchased the
appliance or our service department.
4.
The required installation dimensions can be
found in the installation instructions.
5.
Level the appliance using the
adjustable feet.
Note The device has been checked for
correct operation at the factory. Water
stains may remain on the device. The
water spots are gone after the first
wash cycle.
Pay attention to a firm position.
6.
Install the waste water connection.
→ Page 15
7.
Install the drinking water
connection. → Page 16
The delivery consists of:
s Dishwasher
s Instructions
s Assembly instructions
s Guarantee
1
s Mounting material
s Steam protection plate
1
s rubber patch
1
s Power cord
s Quick guide
1
8.
Connect the device to the power
supply.
Waste water connection
Connect the appliance to a drain water
connection so that the contaminated
washing water can be drained.
Install waste water connection
1.
The necessary steps can be found in
the supplied installation manual.
Setting up and connecting the
device
2.
Connect the drain hose to the
connection nipple of the siphon
using the supplied parts.
You can install your under- or built-in
appliance in the kitchen unit between
wooden and plastic walls. If you
subsequently install the device as a
free-standing device, you must
secure the device against toppling
over, e.g. by screwing it to the wall or
installing it under
3.
Make sure that the drain hose is
not kinked, crushed or tangled.
4.
Make sure that the water does not
flow out by a sealing cap in the
waste water connection.
1
Depending on the device version
15