English |
21
Bosch Power Tools
F 016 L81 430 | (8.9.16)
Troubleshooting
STOP
Problem
Possible Cause
Corrective Action
Machine fails to
operate
Possible clogging
Remove the isolator key:
Check underneath the garden product and clear out
as necessary (always wear protective gloves)
Battery not fully charged
Battery Charging
Battery not inserted (properly)
Inserting the battery
Grass too long
Increase height of cut and tilt garden product to re-
duce starting load
Motor protector has activated
Allow motor to cool and increase height of cut
Battery too hot/cold
Allow to cool/warm
Isolator key not inserted correctly/fully
Fit correctly
There is a short delay in the motor starting after
engaging the On/Off switch
Hold On/Off switch for 1 – 3 s to start motor
Motor starts and stops
immediately
Battery not fully charged
Battery Charging
Isolator key not inserted correctly/fully
Fit correctly
Battery not inserted (properly)
Inserting the battery
Battery too hot/cold
Allow to cool/warm
Increase height of cut
Machine functions
intermittently
Internal wiring of machine damaged
Contact Service Agent
Motor protector has activated
Allow motor to cool and increase height of cut
Machine leaves ragged
finish
and/or
Motor labours
Height of cut too low
Increase height of cut
Cutting blade blunt
Replace the blade
Possible clogging
Check underneath the garden product and clear out
as necessary (always wear protective gloves)
Blade fitted upside down
Refit blade correctly
Area of cut (battery
duration) not large
enough
Height of cut too low
Increase height of cut and walk slower
Grass too high
Increase height of cut and walk slower
Grass wet or damp
Wait until grass is dry and walk slower
Grass is dense
Increase height of cut, walk slower and cut more fre-
quently
An additional battery can be purchased from an
authorised customer service agent for Bosch
garden products
Contact Service Agent
Cutting blade not ro-
tating while garden
product switched on
Cutting blade obstructed
Switch off garden product
Clear obstruction (always wear protective gloves)
Blade nut/bolt loose
Tighten blade nut/bolt (17 Nm)
Excessive vibrations/
noise
Blade nut/bolt loose
Tighten blade nut/bolt (17 Nm)
Cutting blade damaged
Replace the blade
No charging procedure
possible
Battery contacts contaminated
Clean the battery contacts (e.g. by inserting and re-
moving the battery several times) or replace the bat-
tery
The battery is defective, due to a disconnection
in the battery (individual cells)
Replace the battery
OBJ_BUCH-2332-002.book Page 21 Thursday, September 8, 2016 9:24 AM
