Bosch RFSM-A, Installation Manual

Page: 7 / 18

Installation
To determine the proper detector installation location, refer to the Installation guidelines in
this chapter. To install the detector, perform the following procedure:
1.
Remove the sensor from the mounting base by turning the sensor counterclockwise about
15 degrees. The sensor should snap off of the mounting base.
Figure 3.1: Removing the sensor from the mounting base
2. Slide the battery compartment cover away from the detector to unsnap it and lift off.
Figure 3.2: Battery install
Callout
ￚ
Description
1
ￚ
Batteries 3VDC, Lithium (Duracell DL123A, Panasonic CR123A, or Sanyo CR123A)
2 ￚ Battery compartment
3. Observing proper polarity, insert the two 3V lithium batteries into the battery
compartment on top of the battery removal ribbon. Flip the ribbon over the top of the
batteries and replace the battery compartment cover.
4. Remove the red plastic cover from the detector. The detector is shipped with the cover
for protection against dust on construction sites.
5. Using the two screws and anchors provided, mount the base.
6. To attach the detector to the mounting base, do the following:
– Line up the raised alignment tab on the lip of the sensor with the arrow on the mounting
base.
– Insert the sensor into the base and turn clockwise approximately 15 degrees. It should
snap firmly into place.
Notice!
The detector cannot be attached to the mounting base if there are no batteries installed
Test the RFSM-A. See Smoke test and Sensitivity test for more information.
3
RADION smoke Installation | en 7
Bosch Security Systems, Inc. Installation Guide 2013.09 | 02 | F.01U.280.752