Bosch Security Systems | 6/03 | 42597E
EN |
4
RF3401E
| Installation Instructions | 3.0 Mounting
Figure 6: Mount for Extra Security
1 - Security screw
1
Figure 7: Correctly Installed Battery
Cover removed to show detail.
1 - Battery
2 - Tamper switch wires
3 - Wall tamper breakout area
4 - Wire entrance
5 - Release tab
1
2
3
5
Figure 5: Slide the Point Transmitter onto the
Mounting Plate
5. Tear off the loose portion of the ID label to use in
panel programming (see Section 5.0 Panel
Programming).
6. Depending on which case your transmitter comes
with (see Figure 4), open the transmitter cover by
inserting a small flat-blade screwdriver into the slot
at the end of the transmitter. Then push in with the
screwdriver until the latch opens.
7.
Slide the point transmitter over the mounting plate
to lock it into place (see Figure 5). If connecting an
external device, make sure its wiring is pulled
through the wire entrance of the point transmitter as
the point transmitter slides onto the mounting plate.
8. Make the wiring connections for any external
device. Refer to Section 4.0 Setting Up Magnetic or
External Contacts.
Figure 4: Open the Point Transmitter
1 - Insert screwdriver and push here.
2 - Push in.
1
1
9. If the installation requires additional security, use an
additional panhead screw to mount the point
transmitter (see Figure 6).
10. Install a recommended battery (see Section 2.0
Specifications). Be sure to observe the proper polarity
(see Figure 7).
11. Close the cover.
12. Release the point transmitter from the base by
disconnecting any external wiring and removing the
security screw (if used). Then press the release tab
(see Figure 7) with a small tool and slide the point
transmitter off the mounting plate.
