Bosch Rexroth SD301, Manual, Page: 21 / 76

4 Assembly
3 609 929 827/06.06 | SD301 Bosch Rexroth AG 21 /76
4.2 Sliding the display onto the
holder
The system display is placed on the holder’s
enclosure side groove and pushed back
lightly until it reaches the stopper.
Figure 7: Sliding the SD301 system display onto the
SBH301
The SD301 system display can be taken off
the holder for operations.
4.3 Connecting the system
display
4.3.1 Connection to SE302, SE31x,
SEH3x2, KE31x
The system display is connected to the tight-
ening controller’s X6 interface with the con-
necting cable. Use the connection cable in
chapter 7.2 „Accessories“ for this purpose.
4.3.2 Connection to SE301, KE300
Connection cables for extra power supply
(see chapter
7.2 „Accessories“ ) are need-
ed for connections to tightening controllers
SE301 and KE300.
Figure 8: Connection to SE301, KE300
The black lead is connected to a 0 V terminal
(pin 5, 6, or 7), and the black lead with a red
line to the +24 V terminal (pin 1) of interface
X4 on the VM300. The power can also be
supplied by an SE3x1, SE3x2 or SEH3x2 (in-
terface X7: +24 V to pin 5, 0 V to pin 6).
Important :
Always connect the +24 V/0 V ca-
bles when using connection ca-
bles for extra power supply.
BTB
FG
FGI
PV
FI
BL
LI
ST1
ST2
ST3
TF
RESET
MOTOR
EC 48
EC 37 USP
NTF TFVM
BTBVM
0
OFFSET T n
GAIN I m
NI0-QUITT
SBH301 SBH301
+24V/0V
24V
0V
VM300
x4
☞