REFUspeed RS51
Operator control and visualization
6-7
DOK-RD500*-RS51*******-IB02-EN-P
Note:
The terms “D parameter” and “Variable parameter source” are
explained in the legend for the function charts, refer to the
documentation “Function charts and parameter list”.
The last 10 faults are saved in the fault memory. The youngest fault is in
memory location S0, the oldest in S9. A new fault is always saved at
memory location S0. All of the older faults are shifted upwards by one
position in the memory. This means that the fault at memory location S9
is lost.
The existing V/Hz characteristic is graphically displayed in this menu.
Using “Search for D parameter” a list of “Variable parameter sources” is
displayed in which the selected D parameter is connected. You can scroll
through the list using the Enter key. If the selected D parameter is not
linked to a “Variable parameter source”, the following is displayed: “Is not
linked”. For a more detailed explanation, refer to the function charts with
legend.
Operating display
From ten display values, three can be selected for display in the operating
display, refer to P0037.0x in the drive setting.
fact
50.00 Hz
fset
50.00 Hz
operation
0
Line 1: Frequency actual value
Line 2: Frequency setpoint
Line 3: Status (operating status)
Active parameter in normal operation.
The system changes-over into the
test mode when the and
key are simultaneously pressed.
"0T" is then displayed.
Fig. 6-9: Operating display
Warning display
If a critical operating status occurs, then the warning message and the
operating display are displayed alternating until the critical status has
been resolved.
Warning
Motor overtemp.
fact
50.00 Hz
fset
50.00 Hz
operation
0
Fig. 6-10: Warning display
Fault display
The fault display replaces the operating display when an operating status
occurs which initiates a fault.
Fault memory
Graphic display
Search for D parameter
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
