Bosch Rexroth PST 6 0 Series, Operating Instructions Manual

Page: 242 / 330

1070080029 / 05 Bosch Rexroth AG Electric Drives
and Controls PST 6xx0 | | 242 /330
Information on this product
5.2.4.9 ”DEV-NET” (DeviceNet) I/O module
Features:
•
8 discrete inputs (24V
DC
)
• 8 discrete outputs (24V
DC
)
• DeviceNet connection via bus copper cable
Function:
•
Linking the timer's I/Os to the higher-level PLC or the robot
•
via DeviceNet with bus copper cable (serial I/Os) and
• via discrete 24 V signals at X11 and X12 (parallel I/Os).
Table15: Technical data: ”DEV-NET“ I/O module
Operating voltage +24 V
DC
+20 %, -15 %
with max. +/- 5 % ripple
Power input max. 2 A
subject to circuitry connected to the signal inputs/
outputs
Power loss 0.5 VA per active input
2.4 VA per active output
Signal inputs
Signal outputs
logic 1: +16 V ... +30 V, 20 mA
logic 0: -1 V ... +4 V
+24 V, max. 0.1 A, short-circuit-proof
Voltage supply
Connection: X10: 4-pole;
STKK, grid 3.5 mm, max. 1.5 mm
2
.
Mating connector is comprised in the delivery.
Cable length: (from power source to consumer)
max. 10 m at 0.75 mm
2
max. 75 m at 1.5 mm
2
Cable type: unshielded, VDE 0281, 0812 (e.g.: Ölflex)
Discrete signal outputs and inputs
Connection: X11...X12: 8-pole;
STKK, grid 3.5 mm, max. 1.5 mm
2
.
Mating connector is comprised in the delivery.
Cable length: max. 100 m at 0.5 mm
2
Cable type: unshielded, VDE 0281, 0812 (e.g.: Ölflex)
DeviceNet connection
Connection: X13
Cable length: according to DeviceNet specification
Type: copper cable, according to DeviceNet specific­
ation
DeviceNet address: Setting via NA switch. Address (MAC ID) ac­
cording to DeviceNet specification.
DeviceNet baud rate: Setting via DR switch.
According to DeviceNet specification.
ENGLISH