Bosch Rexroth PST 6 0 Series, Operating Instructions Manual

Page: 196 / 330

1070080029 / 05 Bosch Rexroth AG Electric Drives
and Controls PST 6xx0 | | 196 /330
General information on damage to property and products
3.3 Electrical connection
NOTICE
Incorrect voltage supply
Possibility of damage to the electrical equipment!
"
Check whether the supply voltage coincides with the nominal vol­
tage indicated on the nameplate of the product!
The product may only connected to the mains if these values coin­
cide.
"
Make sure that fluctuations or deviations of the supply voltage
from the nominal value always range within the permitted tole­
rance limits (refer to technical data).
Capacitive or inductive interferences in the cables
Possibility of function disturbances!
"
Install the power lines and control cables separately.
The following clearances are recommended:
> 100 mm with parallel installation of cables < 10m,
> 250 mm with parallel installation of cables > 10m.
" The product should be installed in close proximity to the welding
equipment in order to keep the lengths of the necessary connec­
tion cords to a minimum
.
Plugging or unplugging modules or connectors/terminals into/from
live systems
Possibility of damage to the electrical equipment, unexpected
plant reactions!
" Unless described otherwise, never unplug or plug any connec­
tors/terminals on live systems.
" The timer's power supply should always be disconnected before
inserting/removing any timer modules.
ENGLISH