Bosch Rexroth PSI 6100 L1 Series, Operating Instructions Manual

Page: 276 / 460

1070080028 / 08 Bosch Rexroth AG PSI 6xxx | 276 /460
Information on this product
5.2.3.1 Partial front-panel view PSI 6x00.xxx
A
D
R
V24 connection to programming terminal (for programming on location).
Refer to Sect. 7.2.5 from page 363.
”Boot” key for calling up the ”Boot” mode. Required for a firmware upgrade
in connection with the ”WinBlow” software (refer to page 399). Welding is
not possible in ”Boot” mode. Exiting Boot mode: Toggle 24 V logic voltage
off / on.
Boot LED; red. Is on while the timer is in ”Boot” mode.
DIP switch. Function depends on timer type.
LOGIC LED; green. Is on when 24 V
DC
(logic
power supply) is available.
READY LED; green. Is on if no error is present in the timer. The
unit is ready for welding.
BATTERY FAULT LED; red. Is on if a new battery is to be inserted
(refer to page 396).
X4
X5
X8
X2
X9
X3
Measuring input for secondary current measurement.
Refer to Sect. 7.2.14 on page 377.
Type-dependent: Output/input for monitoring the transformer temperature
(refer to Sect. 7.2.15 on page 380).
Type-dependent: Analog output for force actuating variable. Refer to Sect.
7.2.12 from page 374.
Type-dependent: Digital (24 V
DC
) and analog (0..10 V
DC
) input for (force)
feedback. Refer to Sect. 7.2.13 from page 375.
24 V
DC
output for power supply to I/O module (refer to page 367).
24 V
DC
output of the internal voltage source (refer to page 366).
24 V
DC
input for logic power supply (refer to page 365).
Terminals for 24 V
DC
voltage distribution (refer to page 368).
Temperature-controlled 24 V
DC
supply output for the supply/control of external
fans (refer to page 372).
Battery for buffering the unit's internal RAM (for replacement of battery,
please refer to page 396).
Type‐specific
I/O
module. Refer to page 292
et seq.
Optional ultrasonic or U/I controller system (PSQ 6000 XQR)
RESET button. Returns the timer to READY state when a fault has occur­
red (and has been corrected).
DC LINK CIRCUIT LED; red (only operative if LOGIC LED is illumina­
ted in green).
Is on if DC link voltage is present.
24 V
DC
output, e.g. for power supply to external consumers.
Refer to Sect. 7.2.11 on page 373.
Type-dependent: Output for ”Operate” signal output.
Type-dependent: Analog input for (force) feedback. Refer to Sect. 7.2.13 from
page 375.
Type-dependent: 0 V reference for output ”Operate”.
WELD TIME LED; yellow. Is on while the power unit is activated.
Optional fieldbus module. Refer to page 280
et. seq.
Terminals for ”Main switch release“ (refer to page 382)
X1
Fig.7:Partial front-panel view PSI 6x00.xxx
English