Bosch rexroth MCL, Project Planning Manual

Page: 70 / 206

Product
Abbrev. column 1 2 3 MCP is the designation of the primary part of an ironless linear motors.
Frame size
Abbrev. column 4 5 6 The motor frame size is derived from the active motor length and represents
different power ranges.
Frame lengths
Abbrev. column 7 Within a series, increasing motor frame length is graded by means of code
letters.
Winding
Abbrev. column 9 10 11 12 The specified winding designation is done via a preceeded “V” for a DC bus
voltage of 300 V
DC
, with a preceeded “L” for a DC bus voltage of 48 V
DC
.
Cooling
Abbrev. column 14 MCP primary parts are only available with self cooling.
Frame shape
Abbrev. column 15 Two different frame sizes are available, depending from the frame size. The
frame size is derived from the cross section of the respective primary part
and is described by the letters “T” and “I”.
Hall unit
Abbrev. column 17 18 Primary parts in frame sizes 020 up to 070 can be optionally fitted with a Hall
unit for position acquisition. Depended from the frame size, the following Hall
units with different output signals are available:
●
L1 = analog
● L0 = digital
● N0 = none
The cable output direction of the Hall unit is done to the same front side as
for the power connection.
The necessary length measuring system is not in the scope of delivery of
Bosch Rexroth and must be provided and mounted by the machine manufac‐
turer.
Electrical connection
Short-text column 19 20 All primary parts are fitted with a flexible and shielded connection cable. The
connection cable is fixed with the primary part and is done at the front side at
MCP020 up to MCP070, laterally for the MCP015.
Other designs
Abbrev. column 22 23 24 25 NNNN = no other design.
62/197
Identification
MCL Ironless Linear Motors
Bosch Rexroth AG R911330592_Edition 06