Bosch rexroth MBT, Manual

Page: 328 / 422

12.6 Mounting stators with cooling jacket and mounting ring (Op‐
tional)
● To facilitate assembly, Bosch Rexroth provides a mounting
ring for frame sizes 450 and 530. For more information on
the mounting ring, please refer to chapter 7 "Accessories"
on page 229 .
● All screwed connections are equipped with a liquid screw
lock. Refer to Chap.12.3 .
The following figures show the general mounting sequence. Comply with the
machine manufacturer's special mounting instructions. For details about ex‐
isting threaded holes, tightening torques and screw-in depths, please refer to
the particular rotor or stator dimension sheet.
Mount the motor according to the following schematic procedure:
1. Lower the prepared machine housing down to its final position while it is
centered over the stator-rotor package. While doing so, ensure that the
stator centering device appropriately guides the housing and that the
housing does not get jammed.
1
2
3
① Rotor
② Stator
③ Mounting ring
Fig. 12-6: Mounting the stator-rotor package
2. Fasten the stator flange to the stator and also to the machine housing
using the mounting screws ④ and ⑤.
316/409
Installation
MBT High Synchronous Torque Motors
Bosch Rexroth AG R911298798_Edition 08