Bosch Rexroth lndraDrive HCS02 Series, Project Planning Manual

Page: 269 / 382

occurring current load and minimum required
connection cross section
A see technical data of device used (I
L_cont
, I
L_max
and A
LN
)
occurring voltage load V see technical data of device used (U
LN
)
short circuit protection A1, A2, A3 against each other and each of them against
ground
Fig.8-22: Function, pin assignment, properties
8.6.7 X5, Motor Connection HMS01.1N-W0350
View Identification Function
A1 for power connection U1 at motor
A2 for power connection V1 at motor
A3 for power connection W1 at motor
for equipment grounding conductor of motor
Terminal block Unit Min. Max.
screw thread M10
tightening torque Nm 16 20
connection cables
stranded wire with ring cable lug
mm 2
1×16; 1×25; 1×35; 1×50; 1×70; 1×120
2×16, 2×25; 2×35; 2×50; 2×70; 2×120
AWG 1×6; 1×4; 1×2; 1×1; 1×1/0; 1×2/0; 1×4/0
2×6; 2×4; 2×2; 2×1; 2×1/0; 2×2/0; 2×4/0
occurring current load and minimum required
connection cross section
A see technical data of device used (I
L_cont
, I
L_max
and A
LN
)
occurring voltage load V see technical data of device used (U
LN
)
short circuit protection A1, A2, A3 against each other and each of them
against ground
Fig.8-23: X5, motor connection
8.7 X6, Motor Temperature Monitoring and Motor Holding Brake
8.7.1 Important Notes
DANGER
Lethal electric shock caused by live parts with more than 50 V!
Exclusively operate the device with plugged on connector and connected
equipment grounding conductor!
Project Planning Manual | Rexroth IndraDrive Electric Drives
and Controls
| Bosch Rexroth AG 259/369
Functions and Electrical Connection Points