10.3 Mounting
Destruction of components due to mounting
under voltage!
NOTICE
●
Before mounting or demounting components, disconnect the control -
including its components - from voltage
●
Connect the voltage only after the control and its components have been set
up
The extension bus base module can only be mounted if the control is
not attached to the control bus base module.
1. Press the IndraControl extension bus base modules for the IndraControl
extension modules on the top-hat rail on the left next to the control bus
base module until all latchings are safely closed (see (A) in the following
figure).
2. Move the first IndraControl extension bus base module (see (B) to the
right and connect the IndraControl extension bus base module with the
bus base module of the control (see (D) in the following figure).
3. Move the other IndraControl extension bus base modules to the right until
all bus base modules are connected to each other (see (C) in the following
figure).
A
B
D
C
Fig. 10-3: Interconnect extension bus base modules and connect them to the control
bus base module
4. Fit the extension modules and the XMx control on the bus bases.
24/45
Mounting, demounting and electric installation
IndraControl XFE01.1-SY-01 Safety Ex-
tension Module
Bosch Rexroth AG R911376654_Edition 03
