4
Intended Use
The Bosch Rexroth panel PCs are PC-based machine operator and visualization termi‐
nals. Depending on the respective configuration they can also perform control func‐
tions. The are intended for the following use cases:
● As operating, visualization and programming terminal with integrated soft control in
stand-alone-machines.
● As operating, visualization and programming terminal for connected IndraControl
controls.
Danger of destruction of the device if not expressly
stated accessories, mounting parts and other com‐
ponents, cables, lines, software and firmware are
used.
NOTICE
The panel PCs may be used only as intended and with the accessories, mounting
parts, and other components specified in this documentation. Components that are not
expressly mentioned must neither be attached nor connected. The same is valid for ca‐
bles and lines.
Operation must only be carried out with the hardware component configurations and
combinations that are expressly specified and with the software and firmware indicated
and specified in the respective documentation and functional descriptions.
Areas of application of the panel PCs are:
● Handling systems and assembly systems
● Packaging and food processing machines
● Printing machines and paper converting machines
● Machine tools
● Wood processing machines
The panel PCs may only be operated under the mounting and installation conditions,
the position, and the ambient conditions (temperature, degree of protection, humidity,
EMC etc.) specified in this documentation.
Danger of destruction of the touch screen if operat‐
ed with inappropriate objects (e.g. screwdriver).
NOTICE
Operate the touch screen only with your finger or with a special touch pen (parts num‐
ber 1070923266).
DOK-SUPPL*-VSP*XX.3***-IT01-EN-P
Rexroth IndraControl VSP xx.3 Panel PC
Bosch Rexroth AG
Intended Use
9/43
