5-8
Instructions for Use
Rexroth EcoDrive Cs
DOK-ECODR3-DKC*CS*UL**-IB01-EN-P
Equipment Grounding Conductor Connection
DANGER
Lethal electric shock caused by live parts with
more than 50 V!
Connect the equipment grounding conductor connection
of the drive controller to the equipment grounding system
of the control cabinet.
Check the continuity of the equipment grounding
conductors from the mains connection to the connected
motors.
Technical Data of the Terminal Connector
Fig. 5-16:
Equipment grounding conductor connection
Type
Number
Type of design
terminal block
2
threaded terminal end for
M4 ring cable lugs
Fig. 5-17:
Design
Cross section
single-core
[mm²]
Max. cross section
in AWG
gauge No.
2.0
14
Fig. 5-18:
Connection cross section
Contrary to the safety instruction in chapter
1.1
a copper conductor cross
section of 2 mm
2
would be sufficient.
Maximum
1 m
Connection of Control Interfaces and Terminals
See project planning manual for more details.
Graphic Representation
Design
Connection Cross Section
Cable Length
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com
