24/68
Transport and storage
Bosch Rexroth AG
, A4CSG, Series 3x, RE 92105-01-B/06.2017
wARnInG!
Danger from suspended loads!
During transport with a lifting device, the axial piston unit can topple out of the
lifting strap and cause injuries.
▶
Use the widest possible lifting strap.
▶
Make sure that the axial piston unit is securely fixed with the lifting strap.
▶
Only guide the axial piston unit by hand for fine positioning and to avoid
oscillations.
▶
Never stand or put your hands under a suspended load.
▶
Place the lifting strap around the axial piston unit in such a way that it neither
passes over the assembled parts (e.g. valves, sensors) nor that the axial piston
unit is hung from assembled parts.
Fig. 6: Transport with the lifting strap
6.2 Storing the axial piston unit
• The storage areas must be free of corrosive materials and gases.
• To prevent damage to the seals, ozone-forming equipment (for example, mercury-
vapor lamps, high voltage equipment, electric motors, sources of electrical sparks
or electrical discharge) must not be operated in storage areas.
• The storage areas must be dry.
Recommended relative humidity ≤ 60%.
• Ideal storage temperature: +5 °C to +20 °C.
• Minimum storage temperature: -40 °C (exception: units with on-board electronics)
• Maximum storage temperature: +60 °C.
• Keep out of direct sunlight.
• Do not stack axial piston units and store them in a shock-proof manner.
• Do not store the axial piston unit on the drive shaft or assembled parts, for
example, sensors or valves.
• For further storage conditions, see Table 7.
▶
Check the axial piston unit monthly to ensure proper storage.
Transport with lifting strap
Requirements