Bosch REG-D1, Installation Instructions Manual

Page: 16 / 28

- 10 -
4. COLOR OVERVIEW CAMERA LENS
SETTING
The following steps show the installer how to
access the camera board and the camera lens.
Step 4.1 - Remove sunshield by loosening top
bolt with a standard Philips
screwdriver.
Step 4.2 - Disconnect the power source to the
camera and the video signal at the
BNC connector.
Step 4.3 - Remove the four cap screws with a
3mm Allen key. See
Figure 4-1
on
page 11.
Step 4.4 - Carefully slide out the rear housing
from the main enclosure. Make sure
the gasket remains with the rear
section.
See
Figure 4-2
on page 12.
Step 4.6 - Carefully slide the rear section into
the main enclosure and tighten the
cap screws.