Bosch PVQ F2 Series, User Manual

Page: 21 / 32

Power limitation
en
21
20 Power limitation
You can use the PowerManager function to set the total
power of the hob.
The hob is set at the factory; the hob's maximum power
is shown on the rating plate. You can use this function
to adjust the configuration to the requirements of each
electrical installation.
In order to not exceed this set value, the hob automat-
ically distributes the available power as needed
between the cooking zones that are switched on.
While this function is activated, the output of each
cooking zone may temporarily fall below the nominal
value. In order to not exceed this set value, the hob automatically distributes the available power as needed
between the cooking zones that are switched on . The
appliance regulates and selects the highest power level
automatically.
For more information, go to
→
"Basic settings", Page 18
21 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
21.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶
Never use unsuitable cleaning products.
▶
Do not use cleaning products while the hob is still
hot. This may cause marks on the surface.
Unsuitable cleaning products
¡
Undiluted detergent
¡
Detergent intended for dishwashers
¡
Abrasive cleaners
¡
Aggressive cleaning products such as oven spray
or stain remover
¡
Abrasive sponges
¡
High-pressure or steam jet cleaners
21.2 Components to be cleaned or replaced
The following overview shows the components of the
appliance that you either replace or clean.
2
1
3
4
1
Grease filter
2
Odour filter or acoustics filter
3
Glass ceramic
4
Overflow container
21.3 Cleaning the hob
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note:
Note the information on unsuitable cleaning
products. → Page 21
Requirement:
The hob has cooled down.
1.
Remove heavy dirt using a glass scraper.
2.
Clean the hob with a cleaning product for glass
ceramic.
Follow the cleaning instructions on the product
packaging.
Tip:
You can achieve good cleaning results if you
use a special sponge for glass ceramic.
21.4 Cleaning the hob surround
If the hob frame is dirty or stained after use, clean this.
Notes
¡
Observe the information on unsuitable cleaning
products. →
Page 21
¡
Do not use a glass scraper.
1.
Clean the hob frame with hot soapy water and a soft
cloth.
Wash new sponge cloths thoroughly before use.
2.
Dry with a soft cloth.
21.5 Changing the odour filter or acoustics
filter
Change the odour filter regularly. Change the acoustics
filters if they are dirty.
Note:
You can obtain odour filters or acoustics filters
from specialist retailers, customer service or in the on-
line shop.
1.
To keep them in good working order, only use
genuine replacement filters.