English–
3
1 270 020 XBP | (13.4.16)
Bosch eBike Systems
Setting the Assistance Level
On the on-board computer you can set how much the eBike
drive assists you while pedalling. The assistance level can be
changed at any time, even while cycling.
Note:
For individual versions, it is possible that the assistance
level is pre-set and cannot be changed. It is also possible that
less assistance levels are available for selection than listed
here.
The following assistance levels (max.) are available:
–
“OFF”
: The motor assistance is switched off, and the eBike
can be moved as a normal bicycle only by pedalling. The
push assistance cannot be activated in this assistance
level.
–
“ECO”
: Effective assistance at maximum efficiency for
maximum cruising range
–
“TOUR”
: Uniform assistance, for touring with long cruising
range
–
“SPORT”
: Powerful assistance for sportive riding off road
as well as for urban traffic
–
“TURBO”
: Maximum assistance, supporting highest
cadence for sportive riding
To
increase
the assistance level, short-press
the button
“+”
6
on the on-board computer repeatedly until the required
assistance level appears in indicator
i
. To
decrease
the assis-
tance level, short-press
the button
“–”
5
.
Switching bike lights on/off
In the version which has the bike lights powered by the eBike
system, medium-press
the button
“+”
to switch on the
front and rear lights at the same time. To switch off the bike
lights, long-press
the button
“+”
.
The lighting symbol
h
is displayed when the light is on.
Switching the bike light on and off has no effect on the back
lighting of the display.
Displays and configurations of the on-board
computer
Speed and Distance Indication
The
speed indication
a
always displays the current speed.
Indicator
i
always displays the last setting as standard. Repeat-
edly medium-press
the button
“–”
to display the trip dis-
tance
“TRIP”
, the total distance
“TOTAL”
and the range of the
battery pack
“RANGE”
one after the other. (Short-pressing
the button
“–”
will decrease the assistance level!)
The trip distance
“TRIP”
is reset by simultaneously long-
pressing
the buttons
“+”
and
“–”
. The display will initially
show
“RESET”
. If you continue to press both buttons, the trip
distance
“TRIP”
will be set to
“0”
.
You can switch the displayed values from kilometres to miles
by holding down button
“–”
and briefly pressing the
On/Off button
1
.
The versions of the subsystems can be displayed for the pur-
poses of servicing. With the system
switched off
, simultane-
ously press buttons
“–”
and
“+”
and then press the On/Off
button
1
.
The USB socket is reserved for connecting diagnostic sys-
tems. The USB socket does not have any other function.
The USB connection must always be completely sealed
with the protective cap 8.
Action
Buttons Duration
Switch on on-board computer
Any
Switch off on-board computer
Any
Increase assistance
+
Decrease assistance
–
Display
“TRIP”
,
“TOTAL”
,
“RANGE”
,
assistance modes
–
Switch on bike lights
+
Switch off bike lights
+
Reset trip distance
– +
Activate push assistance
Perform push assistance
WALK
+
1.
2. Any
Switch from kilometres to miles
–
1. Hold
2.
Display the versions
1)2)
– +
1. Hold
2.
1) The eBike system must be switched off.
2) The information is shown as scrolling text.
OBJ_BUCH-2819-001.book Page 3 Wednesday, April 13, 2016 3:29 PM
