English |
21
Bosch Power Tools
2 609 004 215 | (31.5.10)
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
Replacing the Sanding Plate
(see figure F)
n
Slide the SDS button for release of the sand-
ing plate
6
all the way to the right.
o
Remove the sanding plate
5
.
p
Guide the sanding plate
5
from below
against the sanding plate holder and firmly
press them together.
q
Slide the SDS button for release of the sand-
ing plate
6
all the way to the left.
If, e. g., the front tip of the sanding sheet is
worn, you can also remove the complete sand-
ing plate and reattach it turned by 120°.
Specialty Sanding Plates
You can replace the supplied sanding plate
5
with a specialty sanding plate, which is available
as an accessory.
The specialty sanding plate is attached in the
same manner as the one supplied.
Attach and remove the respective sanding
sheets in the same manner as when changing
original sanding sheets.
Pad Extender (see figure G)
With the pad extender
14
you can sand surfaces
that are difficult to access, such as sills on win-
dows, cabinets or doors.
Pad Extender, Narrow (see figure H)
With the narrow pad extender
15
you can sand
narrow openings, slots and passages.
Pad Extender, Narrow Rounded (see figure I)
The narrow rounded pad extender
17
allows you
to sand curved and hollow areas or surfaces that
are curved inward, such as on furniture, rails or
heating radiators.
Operation
Starting Operation
Inserting the Battery
f
Use only original Bosch lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool.
Using other batteries can
lead to injuries and pose a fire hazard.
Switching On and Off
To
start
the machine, push the ON/Off switch
8
downward to position “
1
”.
To
switch off
the machine, push the On/Off
switch
8
upward to positon “
0
”.
Battery Charge-control Indication
The battery charge-control indicator
7
indicates
the charge condition of the battery when the
machine is switched on. It consists of 3 green
LEDs.
Grain size
For the working of all
wooden materials
40—180
For coarse-sanding, e. g.
of rough, unplaned beams
and boards
coarse
40
For face sanding and plan-
ing small irregularities
medium 80, 120
For finish and fine sanding
of wood
fine
180
For the working of paint/
enamel coats or primers
and fillers
40—180
For sanding off paint
coarse
40
For sanding primer
medium 80, 120
For final sanding of prim-
ers before coating
fine
180
OBJ_BUCH-1201-001.book Page 21 Monday, May 31, 2010 1:04 PM
