English |
17
Bosch Power Tools
1 609 929 V02 | (13.10.09)
Assembly
f
Before any work on the machine itself, pull
the mains plug.
Auxiliary Handle (see figure A)
f
Operate your machine only with the auxilia-
ry handle 10.
The auxiliary handle
10
can be set to any posi-
tion for a secure and low-fatigue working pos-
ture.
Turn the wing bolt for adjustment of the auxilia-
ry handle
9
in anticlockwise direction and set
the auxiliary handle
10
to the required position.
Then tighten the wing bolt
9
again in clockwise
direction.
Adjusting the Drilling Depth (see figure A)
The required drilling depth
X
can be set with the
depth stop
11
.
Press the button for the depth stop adjustment
8
and insert the depth stop into the auxiliary
handle
10
.
The knurled surface of the depth stop
11
must
face upward.
Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth
X
.
Changing the Tool (see figure B)
Keyless Chuck
Hold the rear sleeve
3
of the keyless chuck
1
tight and turn the front sleeve
2
in rotation di-
rection
n
, until the tool can be inserted. Insert
the tool.
Hold the rear sleeve
3
of the keyless chuck
1
tight and firmly turn the front sleeve
2
in rota-
tion direction
o
by hand.
Screwdriver Tools
When working with screwdriver bits
14
, a uni-
versal bit holder
13
should always be used. Use
only screwdriver bits that fit the screw head.
For driving screws, always position the “Drill-
ing/Impact Drilling” selector switch
4
to the
“Drilling” symbol.
Replacing the Drill Chuck
f
For power tools without spindle lock, the
drill chuck must be replaced by an author-
ised after-sales service agent for Bosch
power tools.
The drill chuck must be tightened with a
tightening torque of approx. 6–8 Nm.
Dust/Chip Extraction
f
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one’s health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Operation
Starting Operation
f
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Reversing the Rotational Direction
(see figures C–D)
The rotational direction switch
7
is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch
6
actuated.
OBJ_BUCH-365-004.book Page 17 Tuesday, October 13, 2009 1:51 PM
