English - 3
Inserting Router Bits (see figure
)
■
Before any work on the machine itself, pull the
mains plug.
■
It is recommended to wear protective gloves
when inserting or replacing router bits.
Fold down chip shield 15.
Press spindle lock button 18 and keep de-
pressed. If required, turn the spindle by hand until
the lock engages.
■
Press the spindle lock button only when at a
standstill.
Insert router bit. The shank of the router bit must
be inserted at least 20 mm (shank length).
Tighten the tightening nut 17 with the open-end
spanner 25 (size 19 mm). Release the spindle
lock button 18.
Fold up chip shield 15.
Do not tighten the tightening nut of the
collet without a router bit inserted.
■
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust /chip extraction and
wear a dust respirator.
■
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
Mounting the Extraction Adapter
(see figure
)
Press the chip shield 15 together at the holding
fixture on the base plate and remove it.
Fasten dust-collection adapter 27 to base
plate 12 with both knurled screws 26 and connect
vac via suction hose 28 (accessory).
☞
When mounting the extraction adapter,
ensure correct mounting position!
For dust extraction, the 35-mm-Ø vacuum
hose 28 can be connected directly to the extrac-
tion adapter.
Clean the extraction adapter 27 regularly to en-
sure optimum dust extraction at all times.
The machine can be plugged directly into the re-
ceptacle of a Bosch all-purpose vacuum cleaner
with remote starting control. The vacuum cleaner
starts automatically when the machine is
switched on.
The vacuum cleaner must be suitable for the ma-
terial to be worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching On and Off
For starting operation of the machine, actuate
the lock-off button 20 first, and then press and
hold the On/Off switch 23 afterwards.
POF 1300 ACE: A lamp lights out the routing.
To switch off the machine, release the On /Off
switch 23.
POF 1300 ACE: The lamp slowly goes out.
Speed Preselection
The required speed can be preselected with the
thumbwheel 22 (also while running).
1 – 2 = low speed
3 – 4 = medium speed
5 – 6 = high speed
The required speed is dependent on the material
and can be determined by practical testing.
After longer periods of working at low speed, al-
low the machine to cool down by running it for ap-
prox. 3 minutes at maximum speed with no load.
Dust/Chip Extraction
A
B
Initial Operation
1 609 929 F23 - Buch Seite 3 Montag, 19. April 2004 8:27 08
15 • 1 609 929 F23 • 04.04
