Familiarising yourself with your appliance
en
7
4 Familiarising yourself with your appliance
4.1 Control knob
You can use the control panel to configure all functions
of your appliance and to obtain information about the
operating status.
Use the control knobs to set the flame size increment-
ally.
Burner assigned to the control knob.
Burner off.
Highest power setting and electric ignition
of the burner.
Lowest power setting.
4.2 Burner
You can find an overview of the parts of the burner
here.
1
2
4
3
6
5
5
6
1
Burner cover
2
Burner cup
3
Cap, burner cup
4
Burner cup base
5
Ignition plug
6
Thermocouple for the flame monitoring
5 Basic operation
5.1 Igniting a gas burner
The hob has automatic ignition of the burners.
WARNING ‒ Risk of fire!
Escaping gas may ignite.
▶
If the burner does not ignite after 15 seconds, turn
the control knob to the "Off" position and open the
door or window in the room. Wait at least one
minute before igniting the burner again.
▶
In the event of the burner flames being accidentally
extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least one
minute.
1.
Press the control knob for the selected burner and
turn it anti-clockwise to the highest level.
Keep the control knob pressed in.
a
For all of the burners, sparks are generated and the
flame ignites.
2.
Wait a few seconds and release the control knob.
→
3.
Turn the control knob to the required position.
4.
If the burner does not ignite, turn the control knob to
the off position and repeat the steps described
above. This time, hold the control knob down for
longer (up to 10 seconds).
Note:
Take the following information into account to ensure
that the appliance works correctly:
¡
The burner parts and the pan supports must be in-
serted correctly.
¡
Do not swap the burner caps around.
¡
It is important to keep the appliance clean. Clean
the ignition plugs regularly with a small, non-metallic
brush. Take care to prevent the ignition plugs from
suffering any heavy knocks.
¡
The burner holes and grooves must be clean to en-
sure a correct flame.
→
"Cleaning the burners", Page 9
5.2 Safety system
The safety system (thermocouple) interrupts the flow of
gas if the burners accidentally go out. To ignite the
burner, you must activate the system that enables the
gas flow.
1.
Ignite the burner without releasing the control knob.
a
The flame ignites.
2.
Press and hold the control knob for a further four
seconds.
