Bosch PKY475FB1W, Instruction Manual

Page: 14 / 16

en
Trouble shooting
14
3
Trouble shooting
Trouble shooting
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out by one of our trained after-sales engineers. If
the appliance is faulty, unplug the mains plug or switch
off the fuse in the fuse box. Contact the after-sales
service.
Faults often have simple explanations. Please read the
information in the table before calling the after-sales
service.
The electronics of your appliance are underneath the
control panel. For various reasons, the temperature in
this area may rise sharply.
So that the electronics do not overheat, the appliance is
automatically switched off as required.
”ƒ
or
”…
is
displayed alternately with the residual heat indicator
•
or
œ
.
E-report in the displays
When an error message with "E" appears in the display,
e.g. E0111, switch the appliance off and on again.
If it was a one-off error, the display goes out. If the error
message appears again, call the after-sales service and
quote the exact error message.
Display Error Remedy
None The power supply has been disconnected. Check the household fuse for the appliance. Check whether there is a
power cut by trying other electronic appliances.
All displays flash The touch controls are wet or an object is rest-
ing on them.
Dry the controls or remove the object.
”‹ / ”‡ / ”ˆ
Appliance fault Switch the appliance off and back on again. If this is displayed again, call
the after-sales service.
”ƒ
The appliance has been grilling for a long time
at a high setting. To protect the electronics, the
front heating zone has been switched off.
Wait until the electronics have cooled down sufficiently. Touch any control.
”ƒ goes out.
”… Despite the switch-off by ”ƒ , the electronics
have become hot again. The appliance has
therefore been switched off.
Wait until the electronics have cooled down sufficiently. Touch any control.
”… goes out.
Ӡ and the tempera-
ture flash alternately.
An audible signal can
be heard.
Warning: There is a hot object near the control
panel. There is a risk that the electronics will
overheat.
Remove the object. The fault indicator goes out.
Ӡ and audible signal There is a hot object near the control panel. To
protect the electronics, the appliance has been
switched off.
Remove the object. Wait until the electronics have cooled down suffi-
ciently. Touch any control. Ӡ goes out.
”‰
The appliance was in operation for too long and
has switched itself off.
Switch the appliance on again.
š“ Appliance does not
heat up
Demo mode is switched on Switch off demo mode: Disconnect the appliance from the power supply
for 30 seconds (switch off the household fuse or the circuit breaker in the
fuse box). Touch any touch control in the next 3 minutes. Demo mode will
be switched off.