English |
29
Bosch Power Tools
1 609 929 U75 | (19.7.10)
External Dust Extraction
For dust extraction, a vacuum hose (size
Ø 36 mm) can also be connected to the dust
ejector
21
.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Changing the Tool (see figures D1
–
D4)
f
Before any work on the machine itself, pull
the mains plug.
f
When mounting the saw blade, wear protec-
tive gloves.
Danger of injury when touching
the saw blade.
Use only saw blades whose maximum permitted
speed is higher than the no-load speed of the
power tool.
Use only saw blades that correspond with the
characteristic data given in these operation in-
structions and that are tested and marked in ac-
cordance with EN 847-1.
Use only saw blades recommended by the tool
manufacturer, and suitable for sawing the mate-
rials to be cut.
Removing the Saw Blade
– Bring the power tool into the working posi-
tion.
– Turn the Allen screw
30
with the Allen key
22
provided while at the same time pressing the
spindle lock
28
until it engages.
– Hold the spindle lock
28
pressed and un-
screw the Allen screw
30
in clockwise direc-
tion (left-hand thread!).
– Remove the clamping flange
31
.
– Press lever
3
and swing back the retracting
blade guard
5
to the stop.
– Hold the retracting blade guard in this posi-
tion and remove the saw blade
17
.
– Slowly guide the retracting blade guard
downward again.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Press lever
3
, swing back the retracting
blade guard
5
to the stop and hold it in this
position.
– Place the new saw blade onto the interior
clamping flange
32
.
f
When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Slowly guide the retracting blade guard
downward again.
– Place on the clamping flange
31
and the
screw
30
.
Press the spindle lock
28
until it engages and
tighten the screw turning in anticlockwise di-
rection.
Operation
f
Before any work on the machine itself, pull
the mains plug.
Transport Safety (see figure E)
The transport safety-lock
24
enables easier han-
dling of the machine when transporting to vari-
ous working locations.
Releasing the Machine (Working Position)
– Push the tool arm by the handle
1
down a lit-
tle in order to relieve the transport safety-
lock
24
.
– Pull the transport safety-lock
24
completely
outward.
– Guide the tool arm slowly upward.
Securing the Machine (Transport Position)
– Tighten clamping lever
25
to lock the saw ta-
ble
11
.
– Press lever
3
and at the same time, swing the
tool arm by handle
1
toward the rear until the
transport safety-lock
24
can be pushed com-
pletely inward.
The tool arm is now securely locked for trans-
port.
OBJ_BUCH-880-004.book Page 29 Monday, July 19, 2010 11:56 AM
