Burner ignition &
control
Depress control knob and turn anti-clockwise to “High
flame”position. Hold the knob down for a few seconds
intensity.
shuts off the gas supply if the flame extinguishes for
any reason. To re-ignite, wait 30 seconds for any unburnt
gas to disperse before repeating the ignition procedure
described above.
To turn off the gas supply to a burner turn the control
burner.
“Low flame” graphic= lowest output
Burner
Position
Graphic
Operating instructions
knob clockwise to the “OFF” position. (Refer Fig.
)
If ignition fails depress knob and try again. If flame is
Turn anti-clockwise to set the flame to the desired
not established in 15 seconds release the control
knob and open a door and wait 1 minute before
attempting a new ignition procedure.
If the ignition sparkers are dirty, this makes the burners
harder to light, so you should keep them as clean
“High flame” graphic= higest output
as possible. Clean them using a small brush and
The control knob is used to adjust the flame of the gas
remember that the ignition sparkers must be treated
very gently.
13
1
3
13
Burner locations
depressed for a few seconds to activate
i
t
.
If ignition fails, depress knob again and wait for
ignition.
If your hotplate is equipped
with flame failure device, keep control knob
flame failure device
1
2
1. Medium burner
until the flame ignites.
6
2. Medium burner
3. Wok burner
4. Small burner
5. Control burner
6. Large burner