1 609 929 N18 | (29.1.08)
Bosch Power Tools
18
| English
– Use dust extraction whenever possible.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your coun-
try for the materials to be worked.
Integrated Dust Extraction with Dust Box
(see Fig. A1
– A4)
Attach the dust box
5
onto the extraction outlet
10
until it latches.
While attaching the dust box, make sure that the
holder
9
engages into the corresponding opening
of the machine.
To empty the dust box
5
, press the latching
levers
11
on the side of the dust box (
n
). Pull off
the dust box toward the bottom (
o
).
Before opening the dust box
5
, it is recommend-
ed to loosen the dust from the filter element by
gently striking it against a firm support (as shown
in the figure).
Grasp the dust box
5
by the recessed grip, fold
the filter element
12
upward and empty the dust
box. Clean the thin plates of the filter element
12
with a soft brush.
Note:
The belt sander has a high removal rate. To
ensure optimum dust extraction, empty the dust
box
5
regularly after 5 minutes of operation and
clean the filter element
12
regularly.
Changing the Sanding Belt (see figure B)
– Completely pivot out the clamping lever
13
.
The sanding belt
8
is now loose and can be re-
moved.
– Mount the new sanding belt
8
. Pay attention
that the direction of the arrows on the inside
of the sanding belt correspond with the arrow
direction on the machine housing.
– Pivot the clamping lever
13
back to its initial
position.
– Pick up the machine and switch it on. The belt
run is automatically centred upon switching
on and during the sanding procedure.
If the sanding belt is not centred after switching
on the machine, the belt run must be readjusted
manually, if required. For this, readjust adjust-
ment screw
7
at the front roll using a screwdriver
until the sanding belt
8
runs centred over the
guide plate. Should the belt run still not be cen-
tred after this, then the sanding belt
8
must be
replaced.
Selecting the Sanding Belt
Depending on the material to be worked and the
required rate of removal, different sanding belts
are available:
Operation
Starting Operation
f
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V can
also be operated with 220 V.
Switching On and Off
To
start
the machine, press the On/Off switch
3
and keep it depressed.
To lock the
pressed
On/Off switch
3
, press the
lock-on button
4
.
To
switch off
the machine, release the On/Off
switch
3
or when it is locked with the lock-on but-
ton
4
, briefly press the On/Off switch
3
and then
release it.
Grain size
For the working of all
wooden materials
40
—220
For coarse-sanding,
e. g. of rough, unplaned
beams and boards
coarse
40, 60
For face sanding and
planing small irregu-
larities
medium 80, 100, 120
For finish and fine
sanding of hard woods fine
150, 180,
220
OBJ_BUCH-612-001.book Page 18 Tuesday, January 29, 2008 1:17 PM
