Bosch Nyon, Original Operating Instructions, Page: 21 / 71

English – 21
(19) Drive unit contacts
(20) Operating unit contacts
A) For mounting on the handlebars, custom solutions are possible even without the
use of the handlebar clamps.
To insert the on-board computer (5) , first fit the lower section into the
holder (4) and then press it forward until you can feel that the on-board
computer is fixed in place. Make sure that the on-board computer is firmly
fixed in place.
To
remove the on-board computer (5) , press on the release mechanism (9)
and take out the on-board computer from above.
u
When you park up the eBike, remove the on-board computer.
It is possible that the release mechanism may become jammed by a screw.
To rectify this, remove the holder
(4) from the handlebars. Put the on-board
computer in the holder. Screw the locking screw (18) (M3 thread, 5 mm
long) from below into the corresponding thread in the holder. Mount the
holder back on the handlebars.
Note: The locking screw is not designed to prevent theft.
Bosch eBike Systems 1 270 U20 Nen | (02.10.2020)