Bosch NPD-6001A, Installation Manual

Page: 12 / 24

System overview
Bosch sells two (2) models of midspans (a 60 W model and a 95
W model) that enable remote power over an IP network
connection for specific Bosch IP cameras. Rated for indoor
installation only, the midspans can be installed indoors and
wired to a camera installed outdoors.
Each midspan has a single port and is designed to carry data
and power over a standard CAT5e (or better) cable, delivered
through all 4 pairs.
60 W Midspan
The 60 W midspan (NPD-6001A) enables remote High Power
over Ethernet (High PoE) for various Bosch IP/HD PTZ cameras.
Generating a maximum of 60 W, it complies to both the IEEE
802.3af and the IEEE 802.3at standards, while doubling the
available power.
This model of midspan is necessary to supply power to the
heater for an outdoor AUTODOME 7000 camera.
It can also supply power to a standard model of MIC7000
without an illuminator accessory.
95 W Midspan
The 95 W midspan (NPD-9501A) is a high-power PoH (Power
Over HDBase T) device that provides data and power between
an Ethernet (remote network) switch and a MIC7000 camera. It
supports the proposed standard for a 95 W output device, and
is backwards compatible to both the IEEE 802.3af and the IEEE
802.3at standards (15.4 W and 25.5 W).
This model of midspan can supply power to all models of
MIC7000.
Notes
Note: Do NOT use cross-over cable between the Data & Power
Out port and the camera!
Note: The midspan is not a repeater and does not amplify the
Ethernet data signal.
3
12 en | System overview High PoE Midspans
2015.06 | 3.1 | F.01U.304.912 Bosch Security Systems