Bosch NPD-3001-WAP, User Manual

Page: 9 / 16

Portable camera installation tool Operation | en 9
Bosch Security Systems, B.V. User Guide 2018.12 | 02 |
4 Operation
!
Warning!
Risk of explosion or burns
This device includes a lithium-ion battery pack. To reduce risk of fire or burns, do not attempt
to open, disassemble, or service the battery pack. Do not crush, puncture, short external
contacts, or dispose of in fire or water. Only use the device in temperatures between 0ºC
(32ºF) and 40ºC (104°F). Recycle or dispose of properly.
Water - Do not use this unit near water, for example near a bathtub, washbowl, sink, laundry
basket, in a damp or wet basement, near a swimming pool, in an outdoor installation, or in any
area classified as a wet location. To reduce the risk of fire or electrical shock, do not expose
this unit to rain or moisture.
4.1 Setup
Changing the default passwords
This device contains a wireless access point. Change its default password during initial
configuration to maximize data security.
1.
Connect a laptop or mobile device to the wireless router SSID: Bosch_Installation_Tool
followed by the respective serial number.
2. Insert the default password: 00000000.
3. Open an internet browser and type the IP address 192.168.1.1 to connect.
4. Login to the webpage of the router with the default credentials - admin/admin.
To change the default password of the wireless router:
1.
Click Home.
2. Click Advanced set up.
3. Click Wireless.
4. Click Security.
5. Insert the new password in the Pre-shared Key field.
6. Click Apply.
P
The router will restart. Reconnect the router by using the new password.
To change the default WPA2 key of the wireless network:
1.
Click Home.
2. Click Advanced set up.
3. Click System Management.
4. Click Change Password.
5. Insert the new password in the New Password field.
6. Insert the same password in the Confirmed Password field to confirm.
7. Click Apply.
P
The router will restart. Reconnect the router by using the new password.
Changing the IP range
Before you operate the device, make sure it is in the same IP range as the cameras in order to
access them. This allows the configuration of the cameras even after assigning them an IP
address.
The default IP address range of the WLAN router is 192.168.1.1.
To modify the IP range: